| After sitting in my garage for almost 3 months, I decided
to finally install my Magnusen 3.6" Pulley. I installed it
using Derrick Stinson's Method, and many of the instructions
here are either his or in a modified form.
Above are the two pulleys side by side. The left one of course being the 3.6"
and the right being stock.
Stuff you'll need:
Metric sockets, both short and deep well and extensions.
A torque wrench that goes to 20 ft/lbs. If there is a Trak Auto near you,
they have free tool loaners.
A syringe. I went all over the place looking for a syringe and ended
up finding one at a local Vet for only $0.50!
About 3-4" of air line tubing ( like you get a walmart for fish tanks).
Some rags for any clean-up and to keep the side of your car clean.
>>Next>>
3.4" Pulley which is now on my car.(1)
3.4" Pulley which is now on my car.(2)
|
